LONGYEAR LY44 Drill Rig

Specifications

Comment

A complete and operational drill rig mounted on an early model International 6 x 6 carrier. The carrier cab interior is in remarkably tidy condition for the age of the vehicle. The vinyl upholstery on both drivers and passengers seat is in good condition. Plain painted metal dash, instruments etc in tidy condition. Nonfactory vinyl roof lining is clean and tidy. Painted metal door linings, dash and rear wall lining all reasonably tidy but due for a clean. Exterior panels are presentable no notable rust or damage. The drill rig is fully operational but has had insufficient use in recent years to warrant continued ownership. The main drilling head is powered buy a Detroit 371diesel. 9m high, lattice construction hyd raise mast with hyd side angle adjustment. Two main winches and a wirline winch. High pressure 353 Bean pump mounted at the front of the machine deck powered by a Petter 2 cyl diesel. The machine deck is built from steel chequer plate with hydraulic stabiliser legs in all four corners powered by the truck PTO hyd pump. Generally appears a tidy machine in typical working condition. Looks a though it would be a reasonably straightforward to remove the entire drill rig and refit to a later model carrier if so desired. The carrier is a 1969 International C1800 6x6. Speedo shows 1426 miles. Five speed high / low transmission. Six rod rear suspension. International petrol straight 6 engine. The vendor advises the following depth capabilities: BQ coring =1510m. NQ coring =1190m. HQ coring =795m. PQ coring = 395m.

Tyres

12.00 x 20 Industrial mudgrips. Front casings a little aged - rear casings excellent. Remaining tread: Front axle 50%. Second & Third axles 80% all round.

HD 900  Skid Mounted Rigs

2 x new Drill Rigs for sale on behalf of clients. These Rigs are surplus to requirements   US $ 250,000.00 each ex Auckland NZ.

Rigs come complete with:

- Additional mid section to allow 9 mtr rod pull                        

- Set PQ/HQ/NQ/BQ chuck jaws                                               

- Set 4x hyd levelling jacks                                                      

- Valving for jack operation

- Safety spin cage

- Block heater/thermal valve

- Double V hydraulic foot clamps

- Slips for clamps PQ/HQ/NQ

for more go to --> Rig Manufacturing, Design and Service --> HD900 Skid Mounted Performance Specifications

Please contact us at This e-mail address is being protected from spam bots, you need JavaScript enabled to view it   for queries on this rigs